Parker 690+0015/230/1BS | Repair & Stock

Parker 690+0015/230/1BS | 15 HP (11 kW) 230V VFD

• Series: 690+ AC Variable Frequency Drive
• Power Output: 15 HP (11 kW)
• Voltage Input: 230V ±10%, 50/60Hz
• Enclosure: NEMA 1 (UL Type 1 – standard indoor)
• Brake Configuration: Integrated brake power switch (external resistor required)
• System Board: Fitted

Frequent Failures We Repair 🔧

• ⚡ Overvoltage issues caused by large inertia loads, misconfigured regen settings, or open braking circuits
• 🔋 Undervoltage during brownouts, phase imbalance, or internal power supply failure
• 🚨 Overcurrent triggered by excessive torque demand, shorted motor cables, or shock loads
• 🌡️ Heatsink overheating due to blocked cooling paths or high ambient temperatures
• 🛑 Motor stall alarms under excessive mechanical loads or improperly set stall trip times
• 🔥 Brake resistor overload during repeated deceleration cycles without cooldown
• 💥 Brake switch burnout caused by aggressive stop routines or undersized braking paths
• 📡 COMMS timeouts from poor cable routing, electromagnetic interference, or short time settings
• 🛑 STO board failure — we can fix these internal safety board errors fast
• 🔄 Faulty controller-to-power board communication often caused by internal damage or firmware errors
• 🎯 Speed feedback faults from damaged encoders or misconfigured feedback loops
• ⚠️ Current limit exceeded under sudden torque changes or unbuffered starts
• 🔌 24V power drop caused by short-circuited external control hardware
• 🔻 Phase loss detection errors — internal board issues or external fuse failure
• 💣 DESAT (instant overcurrent) from faulty switching modules or blown IGBTs
• 🔁 VDC ripple excess — bad capacitor bank or unbalanced supply input
• 🧨 Short circuits in braking circuit or current surge in external resistors
• 🚀 Overspeed triggered by faulty speed feedback or parameter mismatches
• 📏 Analog input faults from sensor wiring shorts or incorrect signal configuration
• 🐢 Overcurrent at low speed — typically fixed boost set too high or improper torque tuning
• 🌡️ Motor overheating from cooling failure, thermistor disconnection, or improper motor match

Flexa Systems Delivers Repairs You Can Trust

Flexa Systems repairs and stocks Parker 690+0015/230/1BS drives for businesses across the U.S. Whether it’s tripping at startup, failing under load, or misfiring on braking — we’ll diagnose and restore your drive fast. Our shop is based in Texas, proudly shipping and servicing nationwide.

📌 Important Notes

Please contact us to confirm your exact requirements or verify application compatibility.

Note: Pricing and availability vary depending on unit condition, configuration, and current stock levels.