Kinetix 350 Repair (Allen-Bradley Servo Drives)

We diagnose and repair Allen-Bradley Kinetix 350 single-axis EtherNet/IP servo drives at the component level—no board swapping. Typical work includes power-stage troubleshooting, control-board repair, firmware/config backup/restore, and closed-loop load testing. Every unit ships with a documented test report and a 2-year warranty.

• Drive faults / trips (overcurrent, undervoltage, over-temp, precharge, DC bus)
• Following error / position loss from feedback or tuning problems
• EtherNet/IP communication loss, IP conflicts, parameter corruption
• Thermal/fan failures and blocked airflow causing overheating
• Power section failures (IGBTs, gate drivers, rectifier, precharge circuits)

• Component-level repair for genuine cost savings
• Load-tested with motor before return
• Fast turnaround; rush service available
• Texas-based shop & warehouse, serving all 50 states
• 2-year warranty on the repair

We support the full Kinetix 350 family. Send your exact catalog number with photos/symptoms and we’ll confirm coverage and lead time.
Don’t see it listed on our site? We likely support it—contact us.

1. Free evaluation quote (based on symptoms/photos)
2. Inbound check-in & fault capture
3. Component-level repair & recap as needed
4. Parameter backup/restore & load test
5. Final QA + 2-year warranty

Turnaround is typically ~10 business days; rush service available. Lead time is sensitive to parts availability—we’ll advise up front.

Flexa Systems
860 Hembry St, Suite 401
Lewisville, TX 75057
+1 (254) 254-0005
office@flexa-systems.com

Do you back up and restore parameters?
Yes—when possible we capture the drive configuration and restore after repair.

Can you test under load?
Yes—closed-loop load tests with motor are part of our process.

What warranty is included?
All Kinetix 350 repairs include a 2-year warranty.

Do you offer rush repair?
Yes—we can expedite and overnight parts when feasible.