Parker 690+0015/230/CBS | Repair & Stock

Parker 690+0015/230/CBS | 15 HP (11 kW) 230V VFD

• Series: Parker 690+ AC Drive
• Power Output: 15 HP (11 kW)
• Input Voltage: 230V ±10%, 50/60Hz
• Enclosure: Chassis-style (IP20) — designed for cabinet installation
• Braking Configuration: Brake switch included (external resistor must be added separately)
• System Board: System board is fitted

Issues This Drive Commonly Encounters (We Fix Them All) 🔧

• ⚡ Overvoltage trips due to fast deceleration, bad resistor connections, or excessive back EMF
• 🔋 Undervoltage when power supply is unstable, or input phases are missing
• 🚨 Overcurrent protection kicking in from bad wiring, short circuits, or excessive load acceleration
• 🌡️ Heatsink temperature faults from tight enclosures or fan cooling issues
• ⛔ Motor stalls under load caused by improper torque limit or mechanical binding
• 🔥 Brake resistor overheating due to short braking intervals or wrong sizing
• 💥 Brake switch component wear from repeated stop/start cycles or aggressive ramp settings
• 📶 Communication timeout faults — misconfigured parameters or bad cable connections
• 🛑 STO module problems, often caused by failed safety boards or improper wiring
• 🔄 Logic/power board sync issues — common in older units or power surges
• 🎯 Feedback errors from encoder failure, improper gain settings, or signal loss
• ⚠️ Current limit exceeded warnings — typically tied to load shocks or poor config
• 🔌 24V control circuit drop caused by external shorts or overloads
• ⚡ Phase loss alarms due to supply problems or trace faults inside the unit
• 💣 DESAT fault protection kicks in from faulty IGBTs or bad gate drivers
• 🔄 High ripple DC link voltage — a sign of failing capacitors or phase imbalance
• 🚨 Brake circuit short or overload due to wiring mistakes or resistor failure
• 🚀 Overspeed alarms from faulty feedback or misconfigured PID parameters
• 📏 Analog input errors — typically wiring or input scaling mismatches
• 🐌 Excessive current during low-speed operation — often due to overly aggressive boost settings
• 🌡️ Overtemp trips caused by thermistor open circuits or poor cooling design

Why Flexa Systems?

When your Parker 690+0015/230/CBS fails, Flexa Systems is ready. We diagnose and repair these drives down to the component level, replacing bad logic boards, fixing power stages, or simply correcting misconfigurations. With our Texas-based shop and nationwide reach, you get fast turnaround and expert support.

📌 Important Notes

Please contact us to confirm your exact requirements or verify application compatibility.

Note: Pricing and availability vary depending on unit condition, configuration, and current stock levels.