Fast Turnaround & Testing
Phone support by engineers
Allen-Bradley PowerFlex 700 20BE6P1A2AYNASN0 | 5 kW / 6.1 A VFD
Repair Now or Swap Units — Your Call
If your PowerFlex 700 fails or throws random faults, Flexa Systems can repair your 20BE6P1A2AYNASN0 in-house at the component level or ship you a fully tested replacement unit from our stocked inventory.
Key Specifications
- Input Voltage: 600V AC
- Current (Amps): 6.1
- Power Rating: 5 kW / 7 HP
- Frame: 0
- Enclosure: IP20, NEMA/UL Type 1
- HMI Presence: Blank Cover
- Documentation: Manual
- Brake: Yes
- Internal Braking Resistor: No
- Emission: CE Filter: Yes, CM Choke: Yes
- Comm Slot: N/A
- Control & I/O: Standard | None
- Feedback: None
Most Common Faults We Can Solve
These are frequent PowerFlex 700 issues. We diagnose quickly and repair at the component level.
- Motor Overload: Internal electronic overload trip.
Fix: Lower load below Motor FLA; we confirm FLA programming and motor sizing.
- SW OverCurrent: 1 ms current exceeded its rating (above cont., below HW limit).
Fix: Reduce load/boost/brake volts; we capture waveforms and reset to safe values.
- Transistor OverTemp: Power devices exceeded safe temperature.
Fix: Same as above—cooling & load audit; we replace failed fans/IGBTs and test.
- Heatsink OverTemp: Heatsink temperature above limit (or very low).
Fix: Verify ambient, fan operation, and load; we replace fans and clean/recertify cooling path.
- UnderVoltage: DC bus dropped below the minimum threshold.
Fix: Check incoming AC for sags/interruption; we test input and DC bus health and stabilize with line conditioning if needed.
- Ground Fault: >25% rating current to earth ground detected.
Fix: Meg-check motor and cable for ground; we isolate insulation faults and re-terminate.
- Decel Inhibit: Bus regulation halts decel to limit DC bus.
Fix: Verify line & grounding, add DB resistor or lengthen decel; we configure/supply DB.
Important Notes
Pricing listed on the website is for reference only and is subject to change over time.
Need to verify compatibility? Send a photo or the full catalog number and Flexa Systems will confirm the best match.
We repair and sell Allen-Bradley PowerFlex 700 drives. Whether you need a quick swap or a thorough in-house repair, we’ve got you covered.
- Every unit is evaluated and test-run under load.
- Turnaround & pricing vary with condition, options, and availability.
- Rush service / exchange available on request.
- 12–24 month warranty on repairs and reman units (where applicable).
Free Evaluation • No Fix, No Fee
Component-level repairs and stocked units. Fast help from our Dallas–Fort Worth team — we ship nationwide.
Get Help Now
Describe the fault or attach a photo — we’ll advise the quickest path.
