Factory-Trained Technicians
ISO-compliant process
Allen-Bradley PowerFlex 700 20BD011A3AYNAND0NNAD | 7.5 kW / 11 A VFD
Rapid Repair or Immediate Replacement
If your PowerFlex 700 fails or throws random faults, Flexa Systems can repair your 20BD011A3AYNAND0NNAD in-house at the component level or ship you a fully tested replacement unit from our stocked inventory.
Key Specifications
- Input Voltage: 480V AC
- Current (Amps): 11
- Power Rating: 7.5 kW / 10 HP
- Frame: 0
- Enclosure: IP20, NEMA/UL Type 1
- HMI Presence: LCD Display, Full Numeric Keypad
- Documentation: Manual
- Brake: Yes
- Internal Braking Resistor: No
- Emission: CE Filter: Yes, CM Choke: Yes
- Comm Slot: None
- Control & I/O: Vector | 115V AC
- Feedback: None
Most Common Faults We Can Solve
These are frequent PowerFlex 700 issues. We diagnose quickly and repair at the component level.
- DB Resistance: Internal DB resistor ohms out of range.
Fix: Replace resistor; we supply/fit correct DB module and test.
- Load Loss: Torque current below [Load Loss Level] for set time.
Fix: Verify mechanical coupling; we check level/time and drive feedback.
- Phase U/V/W to Ground: Phase-to-ground fault detected on the output.
Fix: Check motor cable/motor for grounds; replace drive if damage found.
- Decel Inhibit: Bus regulation halts decel to limit DC bus.
Fix: Verify line & grounding, add DB resistor or lengthen decel; we configure/supply DB.
- Drive OverLoad: 110% for 1 min or 150% for 3 s exceeded.
Fix: Reduce load or increase accel time; we profile current vs. cycle and tune ramps.
- Output Phase Loss: Current lost in one/more output phases.
Fix: Check motor/drive wiring; we test phase continuity and repair output stage/wiring faults.
- OverVoltage: DC bus voltage exceeded the maximum value.
Fix: Verify line transients; extend decel time or add a dynamic brake option; we can size/install a DB kit and soak-test the drive.
Important Notes
Pricing listed on the website is for reference only and is subject to change over time.
Need to verify compatibility? Send a photo or the full catalog number and Flexa Systems will confirm the best match.
We repair and sell Allen-Bradley PowerFlex 700 drives. Whether you need a quick swap or a thorough in-house repair, we’ve got you covered.
- Every unit is evaluated and test-run under load.
- Turnaround & pricing vary with condition, options, and availability.
- Rush service / exchange available on request.
- 12–24 month warranty on repairs and reman units (where applicable).
Emergency & Rush Options
We prioritize downtime cases. Ask about evening ship-outs and exchange programs.
Contact Our Team
Fast triage by drive specialists. Nationwide coverage.
