Component-Level Repairs
Core exchange options
Allen-Bradley PowerFlex 700 20BD014A3AYYAEC1 | 10 kW / 14 A VFD
Get it Repaired or Get a Replacement Today
If your PowerFlex 700 fails or throws random faults, Flexa Systems can repair your 20BD014A3AYYAEC1 in-house at the component level or ship you a fully tested replacement unit from our stocked inventory.
Key Specifications
- Input Voltage: 480V AC
- Current (Amps): 14
- Power Rating: 10 kW / 13 HP
- Frame: 1
- Enclosure: IP20, NEMA/UL Type 1
- HMI Presence: LCD Display, Full Numeric Keypad
- Documentation: Manual
- Brake: Yes
- Internal Braking Resistor: Yes
- Emission: CE Filter: Yes, CM Choke: Yes
- Comm Slot: EtherNet/IP
- Control & I/O: Vector | 24V DC
- Feedback: Encoder, 12V/5V
Most Common Faults We Can Solve
These are frequent PowerFlex 700 issues. We diagnose quickly and repair at the component level.
- OverSpeed Limit: Speed correction exceeded [Overspeed Limit].
Fix: Remove overhauling load or raise limit; we re-tune slip/bus regulation.
- SW OverCurrent: 1 ms current exceeded its rating (above cont., below HW limit).
Fix: Reduce load/boost/brake volts; we capture waveforms and reset to safe values.
- Heatsink OverTemp: Heatsink temperature above limit (or very low).
Fix: Verify ambient, fan operation, and load; we replace fans and clean/recertify cooling path.
- OverVoltage: DC bus voltage exceeded the maximum value.
Fix: Verify line transients; extend decel time or add a dynamic brake option; we can size/install a DB kit and soak-test the drive.
- Cntl Bd Overtemp: Main Control Board over-temperature.
Fix: Check board fan and ambient; we replace fans and re-flow/replace the MCB if required.
- UnderVoltage: DC bus dropped below the minimum threshold.
Fix: Check incoming AC for sags/interruption; we test input and DC bus health and stabilize with line conditioning if needed.
- Decel Inhibit: Bus regulation halts decel to limit DC bus.
Fix: Verify line & grounding, add DB resistor or lengthen decel; we configure/supply DB.
Important Notes
Pricing listed on the website is for reference only and is subject to change over time.
Need to verify compatibility? Send a photo or the full catalog number and Flexa Systems will confirm the best match.
We repair and sell Allen-Bradley PowerFlex 700 drives. Whether you need a quick swap or a thorough in-house repair, we’ve got you covered.
- Every unit is evaluated and test-run under load.
- Turnaround & pricing vary with condition, options, and availability.
- Rush service / exchange available on request.
- 12–24 month warranty on repairs and reman units (where applicable).
Same-Day Quote • Repair or Exchange
We repair, test, and ship quickly — or provide a ready-to-ship replacement when available.
Request Service/Quote
Serving all 50 states from Texas. Rush options available.
