Rush Service Available
Same-day evaluation
Allen-Bradley PowerFlex 700 20BD014A3NYYAED1 | 10 kW / 14 A VFD
Component-Level Repair or Like-for-Like Swap
If your PowerFlex 700 fails or throws random faults, Flexa Systems can repair your 20BD014A3NYYAED1 in-house at the component level or ship you a fully tested replacement unit from our stocked inventory.
Key Specifications
- Input Voltage: 480V AC
- Current (Amps): 14
- Power Rating: 10 kW / 13 HP
- Frame: 1
- Enclosure: IP20, NEMA/UL Type 1
- HMI Presence: LCD Display, Full Numeric Keypad
- Documentation: No Manual
- Brake: Yes
- Internal Braking Resistor: Yes
- Emission: CE Filter: Yes, CM Choke: Yes
- Comm Slot: EtherNet/IP
- Control & I/O: Vector | 115V AC
- Feedback: Encoder, 12V/5V
Most Common Faults We Can Solve
These are frequent PowerFlex 700 issues. We diagnose quickly and repair at the component level.
- Input Phase Loss: Ripple indicates a missing input phase or blown fuse.
Fix: Inspect fuses and incoming power; we verify phase balance and replace protection if necessary.
- Load Loss: Torque current below [Load Loss Level] for set time.
Fix: Verify mechanical coupling; we check level/time and drive feedback.
- Phase UV/VW/UW Short: Excessive current between output terminals.
Fix: Check for shorted motor/wiring; we repair/replace damaged output stage.
- Ground Fault: >25% rating current to earth ground detected.
Fix: Meg-check motor and cable for ground; we isolate insulation faults and re-terminate.
- SW OverCurrent: 1 ms current exceeded its rating (above cont., below HW limit).
Fix: Reduce load/boost/brake volts; we capture waveforms and reset to safe values.
- Output Phase Loss: Current lost in one/more output phases.
Fix: Check motor/drive wiring; we test phase continuity and repair output stage/wiring faults.
- UnderVoltage: DC bus dropped below the minimum threshold.
Fix: Check incoming AC for sags/interruption; we test input and DC bus health and stabilize with line conditioning if needed.
Important Notes
Pricing listed on the website is for reference only and is subject to change over time.
Have a question about fit? Email us a label photo or the full catalog number—Flexa Systems will verify the correct unit.
We support Allen-Bradley PowerFlex 700 drives with both in-house repair and stocked replacements to keep you running.
- All units undergo full functional and load testing.
- Quotes reflect unit condition, configuration, and availability.
- Exchange / rush options available when time is critical.
- 12–24 month warranty on qualifying repairs & remans.
Repair & Sales • PowerFlex Specialists
Component-level repairs, reman units, and ready-to-ship replacements when available.
Check Availability
Send your requirement — we’ll match repair or stock options.
