Rush Service Available
Same-day evaluation
Allen-Bradley PowerFlex 700 20BD022A5AYNANB0 | 15 kW / 22 A VFD
Repair Workflow or Immediate Swap
If your PowerFlex 700 fails or throws random faults, Flexa Systems can repair your 20BD022A5AYNANB0 in-house at the component level or ship you a fully tested replacement unit from our stocked inventory.
Key Specifications
- Input Voltage: 480V AC
- Current (Amps): 22
- Power Rating: 15 kW / 20 HP
- Frame: 1
- Enclosure: IP20, NEMA/UL Type 1
- HMI Presence: N/A
- Documentation: Manual
- Brake: Yes
- Internal Braking Resistor: No
- Emission: CE Filter: Yes, CM Choke: Yes
- Comm Slot: None
- Control & I/O: Standard | 115V AC
- Feedback: None
Most Common Faults We Can Solve
These are frequent PowerFlex 700 issues. We diagnose quickly and repair at the component level.
- I/O Comm Loss: I/O board lost comms with MCB.
Fix: Check connectors/noise; we replace I/O board or MCB if needed.
- Heatsink OverTemp: Heatsink temperature above limit (or very low).
Fix: Verify ambient, fan operation, and load; we replace fans and clean/recertify cooling path.
- :
Fix:
- Phase UV/VW/UW Short: Excessive current between output terminals.
Fix: Check for shorted motor/wiring; we repair/replace damaged output stage.
- Transistor OverTemp: Power devices exceeded safe temperature.
Fix: Same as above—cooling & load audit; we replace failed fans/IGBTs and test.
- Drive OverLoad: 110% for 1 min or 150% for 3 s exceeded.
Fix: Reduce load or increase accel time; we profile current vs. cycle and tune ramps.
- Ground Fault: >25% rating current to earth ground detected.
Fix: Meg-check motor and cable for ground; we isolate insulation faults and re-terminate.
Important Notes
Pricing listed on the website is for reference only and is subject to change over time.
Need to verify compatibility? Send a photo or the full catalog number and Flexa Systems will confirm the best match.
We repair and sell Allen-Bradley PowerFlex 700 drives. Whether you need a quick swap or a thorough in-house repair, we’ve got you covered.
- Every unit is evaluated and test-run under load.
- Turnaround & pricing vary with condition, options, and availability.
- Rush service / exchange available on request.
- 12–24 month warranty on repairs and reman units (where applicable).
0
